Wooden Camera D-Box (Sony Venice, V-Mount)
Product #52568 | SKU 258000
Usually ships in 8 - 12 weeks
0.0 (no ratings yet) Thanks for your rating!

Wooden Camera D-Box (Sony Venice, V-Mount)

Product #52568 | SKU 258000
Usually ships in 8 - 12 weeks

Product Features
  • For the Sony Venice camera
  • Adds power distribution
  • Standardized remote start/stop
  • Hot swap abilities
Customer Reviews
0.0 (no ratings yet) Thanks for your rating!
Product Details
  • Product: #52568
  • SKU: 258000
Not currently for sale
Contact us for more information


D-Box (Sony Venice, V-Mount) is a custom version of our popular D-Box that adds power distribution, standardised remote start/stop, and hot swap abilities for the Sony Venice camera. The D-Box main unit attaches to the back of the AXS-R7 or to the V-Mount plate on the camera rear and the Power Strip portion attaches to the top right side of the camera via a 3pin Fischer and the tape hook threaded hole.

Connectors on the D-Box Power Strip are contoured to match the camera profile and connector angle which allows for all cables to be installed with no collisions. The module communicates with the camera and allows any ARRI standard start/stop trigger to be used with the 3pin Fischer port including the ARRI UMC-4 / WCU-4. The DC input on the D-Box is the same as the camera's 4pin XLR connector allowing for an AC Power Supply, External Power Plate, or VCLX block battery to be connected to power accessories and camera during a battery change. When both battery and DC input are utilised, the D-Box defaults to the DC input, leaving the onboard battery fully charged.

Physical fuses have been replaced by a processor controlled amp limit which is settable to 3.8, 5.8, or 9 amps using the slide switch on the operator's side. Should the user exceed the set current for accessories, only the accessory outputs are disabled leaving the camera running normally. Once the current load has been reduced by either removing accessories or reconfiguring, the reset button can be pressed to enable accessory power again.

The "DC IN" and "BATT" LEDs are dual LEDs. This means the LED If battery voltage is above 12.5V the LED will be green. If the battery voltage is below 12V the LED will be red. If the battery voltage is between those values the LED will be orange (red + green). Flashing may occur during phase transition.

Highest quality Anton Bauer components are used in the V-Mount assembly and the unibody power plate design is both extremely durable and lightweight.


  • 1x V-Mount Power Plate
  • 2x 3pin Fischer at 24V with Run Stop
    • Regulator built in to convert battery voltage to 24V
    • Maximum 3A surge, 2.5A sustained shared between connectors
  • 2x 2pin LEMO at 12V unregulated
    • ARRI standard wiring
  • 2x D-Tap at 12V unregulated
  • 1x 5V USB
  • 1x 4pin XLR DC Input
    • Hot swappable with on board battery
    • Capable of providing power to accessories and camera without brick battery attached

Connectors used in this assembly are not manufactured by LEMO but are made to the same specifications and are LEMO compatible.

Please note: This product is also available in Gold Mount.Please contact us for details.

Australian Shipping Via DHL
DHL offers a great express shipping service to Australia from New Zealand. We are proud to be able to offer express shipping to main cities on the east coast of Australia, within the same timeframe ( If not quicker ) than local Australian courier companies. Prior to the Covid-19 outbreak, service standards for these main centers was overnight. However these services have been impacted greatly, and as such the overnight service has been suspended. Overnight shipping will likely resume once things have returned to normal.

Qualifying main centers include:

  • Brisbane
  • Sydney
  • Adelaide

Whilst this service is extremely efficient and will likely be delivered within 1-2 days 99.9% of the time, it cannot be guaranteed. In the case where something were to go wrong with your delivery and it doesn’t arrive within the specified time frame, in most cases it will be delivered by the next day.

While not all major cities are eligible for overnight delivery, they still benefit from this great service. Other centers throughout Australia will have a typical delivery ETA of 2-4 days. (Excluding rural delivery address where this ETA can be extended to an additional three or more days).

If you require urgent shipping and you don’t reside in one of the cities stated above, please contact us and we can find a solution that works best for you.

Please Note: Shipping via DHL is not available to PO boxes and/ or parcel boxes etc.


0.0 (no ratings yet)
Own or use this product?
Give it a quick rating:
Thanks for your rating!
Share your thoughts with other customers:
Write a review
  • Product: Wooden Camera D-Box (Sony Venice, V-Mount)
  • Manufacturer: Wooden Camera
  • Model: 258000
  • SKU: 258000
  • RM Product #: 52568
  • Warranty: 1 year manufacturer warranty