| Mixer |
Input Channels: 40 (32 mono + 2 stereo + 2 return) |
|
Aux Buses: 20 (8 mono + 6 stereo) |
|
Stereo Buses: 1 |
|
Sub Buses: 1 |
|
Input Channel Functions: 8 DCA Groups |
| I/O Inputs |
16 mic/line (XLR/TRS combo) + 1 stereo line (RCA pin) |
|
Outputs: 16 (XLR) |
|
Expansion Slots: 1 |
| DSP |
8 effects + 10 GEQ |
| USB |
34 x 34 USB audio interface, 2-track recording via USB storage device |
| Sampling Frequency |
48 kHz, internal |
| Signal Delay |
Less than 2.6 ms, Input to Omni Out, Fs=48 kHz |
| Total Harmonic Distortion |
Less than 0.05% 20 Hz - 20 kHz @ +4 dBu into 600 Ohms, Input to Omni Out, input gain = min. (measured with a -18 dB/octave filter @ 80 kHz) |
| Frequency Response |
+0.5, -1.5 dB 20 Hz - 20 kHz, refer to +4 dBu output @ 1 kHz, Input to Omni Out |
| Dynamic Range |
110 dB typ., DA converter, 108 dB typ., Input to Omni Out, input gain = min |
| Noise |
Equivalent Input Noise: -128 dBu typ., input gain = max. (measured with an A-weight filter) |
|
Residual Output Noise: -85 dBu, ST master off (measured with an A-weight filter) |
| Crosstalk |
-100 dB (measured with a -30 dB/octave filter @ 22 kHz), adjacent Input/Omni Out channels, input gain = min |
| Power Requirements |
100 - 240 VAC 50/60 Hz |
| Power Consumption |
85 W |
| Analog Inputs |
Input Terminals: Input 1-16, ST In 1,2 |
|
Gain: -6 dB / +66 dB (Input 1-16) |
|
Load Impedance: 7.5 kOhms (Input 1-16); 10 kOhms (ST In 1,2) |
|
For Use with Nominal: 50 - 600-Ohm mics or 600-Ohm lines (Input 1-16); 600-Ohm lines (ST In 1,2) |
|
Sensitivity: -82 dBu (61.6 μV), -10 dBu (245 mV) (Input 1-16); -30 dBV (31.6 μV) (ST In 1,2) |
|
Nominal: -62 dBu (0.616 mV), +10 dBu (2.45 V) (Input 1-16); -10 dBV (316 mV) (ST In 1,2) |
|
Max. Before Clip: -42 dBu (6.16 mV), +30 dBu (24.5 V) (Input 1-16); +10 dBV (3.16 V) (ST In 1,2) |
|
Connector: Combo Jack (XLR-3-31 type or TRS phone) balanced (Input 1-16); RCA pin jack unbalanced (ST In 1,2) |
| Analog Outputs |
Output Terminals: Omni Out 1-16, Phones |
|
Source Impedance: 75 Ohms (Omni Out 1-16); 100 Ohms (Phones) |
|
For Use with Nominal: 600-Ohm lines (Omni Out 1-16); 40 Ohms (Phones) |
|
GAIN SW: +24 dBu position (default) (Omni Out 1-16) |
|
Nominal Output Level: +4 dBu (1.23 V) (Omni Out 1-16); 3 mW (Phones) |
|
Max. Output Level Before Clip: +24 dBu (12.3 V) (Omni Out 1-16); 75 mW (Phones) |
|
Connector: XLR-3-32 type balanced (Omni Out 1-16); stereo phone jack (TRS) unbalanced (Phones) |
| Digital Input/Output |
Terminals: USB (to Host), iPad |
|
Format: USB |
|
Data length 24-bit (USB to Host) |
|
Audio: 34-ch input / 34-ch output, PCM (USB to Host); Playback: MP3 or WAV file data / Record: WAV file data (iPad) |
|
Connector: USB (B-type) (USB to Host); USB (A-type) (iPad) |
| Control I/O |
Terminals: Network, Foot SW |
|
Format: IEEE802.3 (Network) |
|
Level: 10Base-T/100Base-TX (Network) |
|
Connector: RJ-45 (Network); TS Phone (Foot SW) |
| Dimensions (W x H x D) |
48.0 x 13.2 x 40.9 cm |
| Net Weight |
9.2 kg |
